antique furniture

Aug 02, 2011 from Michael Tenuta
RT @: Enlarge a Roll-around Tool Cabinet.

Aug 02, 2011 from Shannon Rogers
Discovered a greater setback on the HTS tool cabinet last night. Note to self, check moisture content of drawer ancestry first

Aug 02, 2011 from Crispin Thomas
woodworking plans: Store-in-a-box tool cabinet: Downloadable Woodworking Plan: Keep tools, hardware, and supplies...

Aug 02, 2011 from Extreme How-To
Develop intensify a Roll-around Tool Cabinet.

Aug 02, 2011 from arty fresha, 5000,
@ you bought their last album in texas you tool cabinet.

A French-Canadian branded biscuit cutter, hardened to make furniture in G's basement.

Principally

Largely

When the top begins to spin the cut away allows clearance for the tray to rot.ate.

The Explication: put the planer and the drill press in the same space.

I calculated that a conventional flip top table pivoting at the catalogue surface would put the top at 42 inches from the floor. The press chuck would be above eye level, too high for relaxing work....

There is a command at either side of the tray at front. They are star knobs with 3/8 threaded shaft running through to a T-nut in the cabinet side.

Note how the front move of the tray is cut away around the cabinet support gussets.

This detail is of the put up of the tray as it begins to pivot. The back is *not* cut away around the gussets, instead the gussets form a categorical stop for the rear structure. Thus the tray will only pivot in one direction, and only 180 degrees.

There are T-nuts...

I was surprised to find that the planer and penetrate press balance each other very well. It takes only one hand to rotate the top, which is almost 160 pounds. I did not think this would be the dispute as the press carries most of it's mass at the top, but the 4 inch offset evens out...

This is the precedent hinge mounted in scrap plywood. It proved to be extremely rigid and easily handles the bending stage of the heavy top tray.

This shows the end of the cabinet. I had to cut away the rear gussets to clear the planer handles. I could have mounted the planer indirectly and had more clearance. Also I added a section of plywood across the bottom for stiffness.

Note in this position, the top is...